Global Machinery Company MX1G100 - Manual (Page 9)

Operation
Starting and stopping
Operational controls
1. Ensure that the tool is in
good condition.
2. Plug the cordset into the
mains socket.
3. Depress the trigger switch (7)
to start the drill and release the
trigger when you wish to stop.
4. Press the lock-on button (5)
whilst the trigger is depressed
if you require continuous
operation. To disengage the
lock-on switch, press the trigger
then release it.
Variable speed trigger switch
1. You can adjust the speed of the drill between zero
and maximum by varying the pressure on the trigger.
The harder you press on the trigger the faster the drill
will operate.
Speed adjustment
1. You can change the maximum
speed setting by turning the
speed dial (8) located on the
trigger switch.
Reversing the direction
of rotation
1. Operate the forward/reverse
selector (6) on the top of
the drill.
2. Push the selector to the
position for forward action.
3. Push the selector to the
position for reverse action.
CAUTION. Any attempt to
reverse the direction of rotation
while the drill is turning is likely
to permanently damage the
switch.
Drilling/hammer mode selector
You can use the drill for both hammer action
and normal drilling.
1. Use the drilling/hammer mode
selector (4) to select hammer or
drill action. The type of drilling
selected is indicated by the
symbol on each side of the drill.
2. Push the selector to for
hammer action.
3. Push the selector to for
drill action.
CAUTION. Change the mode of action only when the drill
has come to a complete standstill.
NOTE. Hammer action drilling should only be preformed in
the forward direction.
9