Global Machinery Company NTS2000A - Manual (Page 9)

9
Assembly
1. Place the fixed support pole
into the base.
2. Secure the fixed support pole
to the base by tightening the
2 recessed hex screws in the
base, use the 5mm hex key to
tighten these screws.
3. Place the adjustable support
pole into the fixed support pole.
4. Position the adjustable
support pole so that the slot
in the pole is in line with the
Phillips head screw.
5. Using a Phillips head screwdriver
tighten the screw so that it
extends into the recess.
6. Lower the adjustable support pole
and let it rest on the Phillips head
screw for support.
7. Attach the tension handle to
the front of the fixed support
pole and tighten, this will hold
the adjustable support pole in
position.
8. Fit the accessory storage
compartment over the
adjustable support pole and
lower down onto the fixed
support pole.
9. With the accessory storage
compartment positioned at the
top of the fixed support pole
tighten the 2 hex bolts
to secure the compartment
in position.
10. Fit the wheel storage
compartments onto
the accessory storage
compartment and using a
Phillips head screwdriver
tighten the 4 pan head
tapping screws to secure
the wheel storage
compartments in place.
11. Fit the bench grinder support
plate onto the top of the
adjustable support pole.
12. Secure the bench grinder
support plate in position by
tightening the 2 recessed
hex screws located
underneath the plate.