GE IMRSEN-W12 - Manual (Page 3)

Catalog Number: RSEN-W12
3
INSTALLATION (CONTINUED)
Checkout and Adjustment
Once installation is complete, restore power to the lighting
circuit. Proper operation of the RSEN-W12 must be verified.
Adjustments should be made with the HVAC system on.
Use only insulated tools to make adjustments.
1. Adjustment controls are under the touchplate. “Time
Delay” ranges from 15 seconds (for testing) to 30 minutes.
Using a small screwdriver, set “Time Delay” to 15 seconds
by turning the control completely counterclockwise until it
stops at minimum setting (approximately 8 o’clock). Turn
control for “Area Range” until flat edge of control is at 10
o’clock. Turn “Entry Range” until flat edge of control is at 9
o’clock.
2. Move the “Mode” switch to the “Auto” or “A” position.
3. The area of coverage can be determined by watching the
LED indicator on the front of the sensor while moving
around the room. The LED lights only when the sensor
detects motion. Adjust the “Area Range” control to the
lowest setting that provides adequate motion detection of
a person working in the room. Do not set higher than
necessary.
4. Leave the room. The lights should go out in approximately
15 seconds. Wait at least 12 seconds after the lights go
out. Walk normally back into the room and verify that the
lights turn on automatically. If not, the “Entry Range”
should be increased slightly. Do not set higher than
necessary.
5. If the LED blinks when there is no movement in the room, it
is possible that the sensor is being activated by air flow
from the HVAC system. Reduce the “Area Range” setting
until the LED goes off and stays off with no motion.
6. If the sensor is activated by passers-by in the hallway,
reduce the “Entry Range” setting.
7. Set “Time Delay” to the desired setting for normal use. If
lights go out while the room is occupied, increase setting
slightly until an optimum interval is obtained. Recom-
mended time delay is usually 6-8 minutes (approximately
10 o’clock). People who remain very still for long periods
may need a longer time delay.
8. If preferred, the RSEN-W12 may be set to Manual ON for
maximum energy savings by moving the “Mode” switch to
the “M” position. In this setting, the occupant must push
the touchplate to turn on lights upon entering the room.
Area Entry
Time
Delay
1/4 30
Range
M A
Switch to M for Manual On
Switch to A for Auto On
Sensitivity
Adjustments,
clockwise
minimum
to
maximum
Time Delay
Adjustment,
clockwise
15 seconds
to
30 minutes
Sensor Adjustment
LOAD 1
NEUTRAL
120 VAC OR 277 VAC
TOGGLE
SWITCH
(OPTIONAL) RSEN-W12
LOAD 2
SWITCH LEG LOAD 1
SWITCH LEG
LOAD 2
Sensor Wiring