GENIUS COLORPAGE HR6A - Manual (Page 19)

Genius ColorPage-HR6A Scanner
17
position to provide further support for the paper.
Figure 8. Sliding the Extension Arm
3. Make sure the paper being loaded is completely flat with no creased corners, etc. Also
remove any staples if present, before loading the page into the ADF.
4. Load the documents face-down into the ADF. The left side of the paper should touch the left
side of the ADF. The documents should be all the way into the ADF, touching the bottom.
Only use normal paper in the ADF. The ADF does not support
transparencies. Please refer to Appendix B: Specifications at the
back of this manual for more detailed information about the
different types of paper that can be loaded into the ADF.
5. Adjust the paper width slider for the paper size you are using. The paper width slider should
be gently touching the right side of the documents.
The loaded documents should now be bordered on 3 sides; the bottom should be all the way in
the ADF touching the bottom, the left side should be touching the left wall of the ADF and the right
side should be touching the paper-width slider.
• Although the documents should be loaded firmly in place ensuring
optimum scanning accuracy, they should never be wedged in so tightly
that the process of feeding them through the scanner is strained.
• The ADF cover should be kept closed when not in use. Make sure to
return the extension arm to its down position before closing the cover
Attention
Attention
Extension Arm