Golden Technologies Power Lift - Manual (Page 6)

Drawings are for illustration purpose only
Your Golden power lift chair has been equipped with the MaxiComfort™ System.
The MaxiComfort System has been designed specifi cally for you. Offering you a
wide range of body positioning, so you can choose the position that best suits your
needs. The MaxiComfort System accomplishes this by providing four primary
motions: three recline, one lift and combinations of those motions, allowing you
to settle into your favorite comfort position. Shown below are some of the Maxi
Comfort positions. There are many to choose from. You may stop your Golden
power lift chair at one of the positions shown or anywhere in between just by
releasing the buttons on the hand control when the chair reaches the position
you desire.
MAXICOMFORT™ POSITIONS
6
Programming the Memory Buttons S5, S9
Using buttons S1 thru S4 move the chair to a position that suits your needs. Use
the following procedure to program the Mem1 and Mem2 buttons.
1. Press and hold program (SP) button, the back light goes off while pressed
2. In about 3 seconds the backlight will start fl ashing (one fl ash)
3. Within 5 seconds, press one of the memory buttons (S5, S9) to save the
position. The back light will return to non-fl ashing on when the position is
stored.
If a programmable memory button is not pressed within 5 seconds, or a different
button is pressed, then the programming sequence is aborted and you will need
to repeat steps 1 to 3 above. You may reprogram the memory buttons as often
as you like.
TV Watching 1 Zero Gravity Like