Operation – Gardena 8000S SP User Manual

Page 5

Advertising
background image

14

GB

Automatic operation :

The universal fitting

7

allows you to connect all the hoses listed

in the previous table.

1. Cut off nipples of the universal fitting

7

, which are not needed,

to match the hose connection.

2. Screw the universal fitting

7

onto the pump.

3. Connect the hose to the universal fitting

7

.

We recommend that you secure 38 mm (1 1/ 2

”) and 25 mm (1”)

hoses additionally with a GARDENA Hose Clip Art. No. 1591.

Only for 13 mm (1/ 2

”) hose :

The universal fitting

7

can also be equipped with a GARDENA

Regulator Valve Art. No. 977 so that the contents of the out-
let line do not flow back through the pump after pumping. The
Regulator Valve can be ordered from your GARDENA dealer.

4. Operation

To ensure that the pump draws the water out, the water to be
drained must be at least 10 cm deep.

The float switch

5

turns the pump on automatically when the

water level exceeds the cut-in height and the water is pumped out.

The float switch

5

turns the pump off again as soon as the water

level falls below the cut-out height.

1. Stand the pump on a firm surface

– or –
use a rope attached through the bore hole in the carrying
handle

2

to immerse the pump in a well or shaft.

During automatic operation, ensure that the float switch

5

can move freely.

2. Plug the power cable

1

into a mains socket.

Adjusting the Cut-in and Cut-out Height :

The maximum cut-in height and minimum cut-out height (see
8. Technical Data) can be adjusted.

v Push the cable of the float switch

5

into the float switch lock

3

.

Do not select a cable length that is too long or short to ensure
that the float switch can turn on and off properly.

• The higher the opening of the float switch lock

3

, the higher

the cut-in and cut-out height.

• The shorter the length of cable between the float switch

5

and the float switch lock

3

, the lower the cut-in height and the

higher the cut-out height.

The cable length between the float switch

5

and the float switch

lock

3

must always be at least 10 cm.

Connecting the hose :

7

1

2

5

3

Advertising
This manual is related to the following products: