Gaggenau AW 200-790 - Manual (Page 19)

For circulating air mode use the installation set
included with the ventilation ducts LK 010-112/122
und LK 011-112/122. You also need an activated
charcoal filter (KF 001-010).
Proceed as follows:
– Slightly loosen the screws of the retaining bracket
for the chimney paneling. Hang the angle pieces
onto the screws and tighten the screws.
– Screw the circulating air switch module to the
angle pieces (4 screws).
– Shorten the flexible air pipe accordingly. Fix the
flexible air pipe with hose clamps (Fig. 24).
– Establish the electrical connection.
– Stainless steel chimney only (LK 010-112/122):
pull the protective film off the chimney’s trims.
Note: avoid damaging the sensitive metal surfaces.
– Fit the top chimney duct unit into the base. Make
sure that the fastening holes on the side are at the
top.
– Put both chimney duct units onto the hood.
– Pull the top chimney duct unit up into its final
position and secure it with 2 screws on the ceiling
holder (Fig. 25).
Note: avoid scratches when pulling the elements
apart by placing the assembly template, for
example, over the edge of the bottom chimney
paneling to protect it.
– Insert the activated charcoal filters.
– Insert the grease filters.
18 9000032538 en 06.05 EB
Fig. 24
Fig. 25