Gateway 920 - Manual (Page 77)

72
Chapter 6: Troubleshooting
www.gateway.com
BIOS
The settings in the BIOS Setup utility are not retained
■ Replace the CMOS battery. For more information, see “Replacing the
CMOS battery” on page 52 .
3 Memory failure in first 64 KB. Same as for 1 beep.
4 Memory failure in first 64 KB of
memory, or Timer 1 on the system
board not functioning. Remove all expansion cards.
■ If the beep code occurs even when all
expansion cards have been removed, the
system board is at fault.
■ If the beep code does not occur when the
expansion cards have been removed, one
of the cards is causing the problem. Install
the cards one at a time until the problem
happens again. When the beep code
returns, the most recent card you installed
is at fault.
5 The processor on the system board
generated an error. Same as for 4 beeps.
6 The keyboard controller (8042) may
be defective. The BIOS cannot
switch to Protected mode. Same as for 4 beeps.
7 The processor generated an
exception interrupt. Same as for 4 beeps.
8 The server video adapter is either
missing or its memory is faulty. This
is not a fatal error. Check or replace the video adapter.
9 The ROM checksum value does not
match the value encoded in the
BIOS. Same as for 4 beeps.
10 The shutdown register for CMOS
RAM failed. Same as for 4 beeps.
11 The external cache is faulty. Same as for 4 beeps.
Beeps Description Troubleshooting steps