Gefen EXT-COMPAUD-44424 - Manual (Page 10)

7
IR CHANNEL CONFIGURATION
How to Resolve IR Code Confl icts
In the event that IR commands from other remote controls confl ict with the
supplied RMT-16IR remote control, changing the remote channel will alleviate
this issue. The RMT-16IR remote control has a bank of DIP (Dual Inline Package)
switches for confi guring the remote channel that both units use to communicate.
The 4x4 Component w/Audio Matrix can be put into a mode that will uses its
front LED array to indicate which remote channel is being used and also give the
user the ability to modify the currently used IR remote channel. These IR channel
settings must exactly match each other for proper operation.
The DIP Switch bank on the RMT-16IR is located underneath the battery cover.
Follow these steps to place the 4x4 Component w/Audio Matrix into IR channel
setup mode.
1. Turn on the 4x4 Component w/Audio Matrix.
2. Press and hold the front panel POWER button for 5 seconds to enter the
setup mode (All output LED’s except for Output 1 will be off). The Output 1
LED source indicator (page 4) will display the currently selected IR channel.
The active LED, either 1, 2, 3, or 4, will indicate which IR channel is being
used.
3. Note the IR channel used on the RMT-16IR remote and press the Output 1
selector button to cycle to the IR channel that is being used.
4. Press the POWER button to save the settings and exit the IR channel setup
mode.
Channel 1:
Default
1 2
Channel 3:
1 2
Channel 2:
1 2
Channel 4:
1 2
Left: Picture of the opened rear battery
compartment of the RMT-16IR remote showing
the exposed DIP Switch bank between the
battery chambers.
Output-1
1
Channel 1
2 3 4
Output-1
1
Channel 2
2 3 4
Output-1
1
Channel 3
2 3 4
Output-1
1
Channel 4
2 3 4