Grizzly Model G0562 - Manual (Page 15)

G0562 3 HP Dust Collector -13-
Components and Hardware Needed: Qty
Base ..................................................................1
Casters ..............................................................4
Flange Bolts
5 ⁄
16
"-18 x 1 ⁄
2
"..................................16
Tools Needed:
Wrench or Socket 12mm....................................1
To assemble the dust collector base:
1. Place the base upside down.
2. Secure the casters into the mounting brack-
ets under the base with the flange bolts
(
Figure 7).
Base
Components and Hardware Needed: Qty
Base ..................................................................1
Motor and Impeller ............................................1
Flange Bolts
5 ⁄
16
"-18 x 1 ⁄
2
"....................................4
Tools Needed:
Wrench or Socket 12mm....................................1
To install the motor and impeller:
1. Flip the base over onto the casters and
locate the mounting holes for the motor and
impeller.
2. Position the motor and impeller on the base
and secure it with the flange bolts (
Figure 8).
Motor and Impeller
Figure 7. Caster installed on mounting bracket.
Figure 8. Motor and impeller attached to base.