Gallien-Krueger NEO SERIES NEO 1001/212 - Manual (Page 6)

6
Neo Series Bass Combo Amplifi er
Front Panel Features
Front Panel Features
1) Balanced Direct Out: An electronically balanced
low impedance output that you can run to your P.A.
system via a mic cable.
2) Ground/Lift: Used to eliminate hum when
connnecting to equipment that is running on a
different ground system.
3) Pre/Post EQ Button: Sets the Direct Out signal
before or after the EQ.
4) Direct Out Level: Controls the output level of
the Direct Out.
5) Input: A standard ¼” input jack to plug
in active or passive basses using an instrument
(shielded) cable.
6) -14dB Pad & Clip LED: Reduces the input
signal from your bass. Press in if the Clip LED lights
up excessively
7) Tuning Mute Button: Mutes all output signals
except for the Tuner output. LED turns on when
“Tuning Mute” is engaged.
8) Volume: Sets the pre-amp gain after the input
stage.
9) 4/5 String Bass: When engaged, this extends the
low frequency range.
10) Contour: Cuts the mid-range frequencies while
boosting lows & highs.
11) Presence: Adds edge and defi nition to higher
frequencies.
12) Treble: Active shelving type control which
boosts and cuts the high frequencies.
13) High Mid: Active bandpass type control which
boosts and cuts at about 1kHz.
14) Low Mid: Active bandpass type control which
boosts and cuts at about 250Hz.
15) Bass: Active shelving type control which boosts
and cuts the low frequencies.
16) Boost: A post EQ gain stage using GK’s exclusive
Valve Effect technology, which adds ‘growl’ as it is
turned up.
17) Tweeter: Master volume control for the 50 watt
horn amp. Output signal is 5kHz and above.
18) Tweeter Hi-Cut: Cuts frequencies above
10kHz, which is useful for reducing hiss from the
tweeter.
19) Woofer/Master: Master volume control
for the woofer (Main) amplifier. Output signal is
full-range.
17 11 10 9 8 7 6 5 4 3 2 1 12 13 14 15 16 18 19 20 21 22 23
25
24