Grizzly H7664 - Manual (Page 14)

H7664 2-in-1 Combination Nailer/Stapler -14 -
A jammed nail or staple must be cleared
before using the nailer/stapler again.
To clear a jammed nail or staple from
the magazine:
1. DISCONNECT THE NAILER/
STAPLER FROM THE AIR
SUPPLY!
2. Unlock the catch lever and pull the
magazine pusher back completely.
3. Locate and remove the jammed nail/
staple with a pair of needle nose pli-
ers.
4. Throw the damaged nail/staple away.
5. Inspect the nail/staple stick. If it is bent
or damaged, throw it away and insert
a new stick that only contains clean,
undamaged nails/staples. DO NOT
use dirty or damaged nails/staples!
6. Push the magazine pusher forward
to the front of the magazine until the
catch lever locks.
Clearing Jammed
Nails/Staples
Single/Bump Fire
Operation
The nailer/stapler is designed to fire one
nail/staple at a time, or one after another,
using the safety yoke mechanism. This is
known as "bump fire".
To operate your nailer/stapler in single
fire mode:
1. Depress the safety yoke mechanism
against the workpiece.
2. Pull the trigger, then remove your finger
from the trigger after the nail/staple is
driven.
To operate your nailer/stapler in bump
fire mode:
1. Pull the trigger.
2. Press the safety yoke mechanism
against your workpiece and raise it
after the nail/staple is driven.
3. Hold the trigger and repeat Step 2 to
drive more nails/staples.