Grizzly H7664 - Manual (Page 6)

H7664 2-in-1 Combination Nailer/Stapler -6 -
1. HAND INJURIES: Do not place
your hands near the nail/staple point
of entry. A nail/staple can deflect
and tear through the surface of the
workpiece, puncturing your hand or
fingers.
2. COMBUSTIBLE GASES: Never
connect the nailer/stapler to pres-
surized oxygen or other combustible
gases as a power source
. Only use
filtered, lubricated, and regulated
compressed air.
3. SAFE HANDLING: Never point
the nailer/stapler at others! Do not
keep the trigger pulled when loading
fasteners, carrying, or holding tool.
Carry the nailer/stapler only by the
handle, never by any other part. Do
not carry the nailer/stapler by the air
hose. Disconnect the nailer/stapler
from the air hose when going up and
down ladders.
4. CLEANING: Never use gasoline or
other flammable liquids to clean the
nailer/stapler; vapors in the nailer/
stapler will ignite by a spark and
cause it to explode.
Additional Safety Instructions for Nailers and
Staplers
5. HOSE USAGE: Make sure your
air hose is designed for the tool
in use, is in good condition, and
is long enough to reach your work
without stretching. However, an
overly long air hose in the work
area may be a tripping hazard.
6. OPERATING QUESTIONS: If you
are not sure about the intended
operation, stop using the nailer/
stapler. Seek formal training or
research books or magazines that
specialize in pneumatic tools.
7. MAINTENANCE: Always discon-
nect air from the nailer/stapler
when servicing or installing nails
or staples. During maintenance, a
nailer/stapler connected to air may
fire accidentally, causing serious
personal injury.
8. COMPRESSED AIR RATING: Do
not connect the nailer/stapler to
compressed air that exceeds 120
PSI.
9. CHECK VALVE: Do not use a
check valve or any other fitting that
allows air to remain in the tool.