GIGABYTE Pentium 4/D Processor Motherboard GA-5EASV-RH - Manual (Page 11)

1 1
Hardware Installation Process
2-1-2: Installing Heat Sink
Step 1.
Please apply heat sink paste on the surface of
the installed CPU.
Step 6.
Attach the power connector of the heat sink to
the CPU fan header located on the motherboard.
Heat sink installation is completed.
Step. 2
( to remove the heat sink, turning the push pin
along the direction of arrow; and reverse the
previous step to install the heat sink.)
Please note the direction of arrow sign on the
male push pin doesn't face inwards before
installation. (This instruction is only for Intel
boxed fan)
Male Push Pin
Female Push Pin
The top of Female Push Pin
Step. 3
Place the heat sink on top the CPU and make
sure the push pins align to the pin hole on the
motherboard.Push down the push pins
diagonally. Step. 4
Please make sure the Male and Female push
pin are brought together. (for detailed installation
instructions, please refer to the heat sink
installation section of the user manual)
Step. 5
Please check the back side of teh motherboard.
Make sure the push pin is seated firmly as the
picture shown.