1 purpose and scope of the manual, 2 safety, 3 standards booklets – Generac Power Systems 009592-5 User Manual

Page 22: 4 equipment description, 5 generator engine operating speed, 6 generator ac connection system

Advertising
background image

20 Generac

®

Power Systems, Inc.

5.1 PURPOSE

AND

SCOPE

OF THE MANUAL

These Installation Instructions have been prepared
especially for the purpose of familiarizing installers and
owners of the applicable equipment with the product's
installation requirements. Give serious consideration to
all information and instructions in the manual, both for
safety and for continued reliable operation of the equip-
ment.
Because of the different recreational vehicle models and
the variations between the models, it would be extremely
difficult, if not impractical, to provide detailed instruc-
tions for every possible installation. For that reason,
instructions and illustrations in this manual are general
in nature. Illustrations are not intended to serve as
detailed installation blueprints.
The installation should comply strictly with all applica-
ble codes, standards and regulations pertaining to the
installation and use of this product. If any portion of
this manual appears to be in conflict with such codes,
standards or regulations, the applicable codes, stan-
dards or regulations must take precedence over the
manual.

5.2 SAFETY

Before handling, installing, operating or servicing this
equipment, carefully read the “Notice to Installer” and
“Safety Rules” on Pages 18 and 19. Comply with all safe-
ty rules to prevent death, personal injury or damage to
equipment and/or property. Stress safety to all
installers, operators and service technicians who work
on this equipment.

5.3 STANDARDS

BOOKLETS

Installation, use and servicing of this equipment should
comply strictly with published standards, as well as the
manufacturer's recommendations. The following stan-
dards booklets (latest revision) are available from the
sources indicated:
1. NFPA Standard 501C, “Standard for Recreational

Vehicles,” available from the National Fire
Protection Association, Batterymarch Park, Quincy,
MA 02269.

2. NFPA 70, “NFPA Handbook of the National Electric

Code,” available same as Item 1.

3. ANSI C1-1975 and ANSI 119.2-1975, available from

the American National Standards Institute, 1430
Broadway, New York, NY 10018.

4. ANSI A119.2/NFPA 501C, available from the

Recreational Vehicle Association, 1896 Preston
White Drive, Reston, VA 22090.

5. California Administrative Code, Title 25, available

from the State of California, Documents Section,
P.O. Box 1015, North Highlands, CA 95660.

6. CSA Electrical Bulletin 946, available from the

Canadian Standards Association, Housing and
Constructions Materials Section, 178 Rexdale
Boulevard, Rexdale, Ontario, Canada, M9W 1R3.

5.4 EQUIPMENT

DESCRIPTION

Instructions and information in this section pertain to
Generac air-cooled generators. These generators are
designed specifically for installing in recreational vehi-
cles. They operate 120-volt, single-phase, 60-Hertz, AC
electrical loads that require 40.0 amps (gasoline) or
37.5 amps (LP fuel) at 120 volts.

5.5 GENERATOR

ENGINE

OPERATING SPEED

The generator’s revolving field (rotor) is driven by a sin-
gle-cylinder, four-cycle engine through a pulley and drive
belt arrangement. The generator supplies 120 volts AC
at 60 Hertz when the rotor is operating at 3,600
rpm.The drive belt arrangement allows the engine to
operate at a lower speed than the rotor.

5.6 GENERATOR

AC

CONNECTION SYSTEM

The generator is equipped with dual stator power wind-
ings as shown in Figure 1.1.

Figure 5.1 – 120-volt Single Voltage Connection

• The AC connection system on all air-cooled

PRIMEPACT series generators uses a GROUNDED
neutral.

• A separate green ground wire is connected to the

recreational vehicle’s junction box.

• For these PRIMEPACT units, loads connected across

T1 (red) to T2 (white), MUST NOT exceed 30
amperes or 3,600 watts, and loads connected across
T3 (black) and T2 (white) MUST NOT exceed 20
amperes or 2,400 watts each at 120 volts. The com-
bined loading of the two breakers should not exceed
5,500 watts.

NOTE:

Do NOT connect loads in excess of circuit
breaker ratings.

Section 5 – General Information

PRIMEPACT 55G and 55LP Recreational Vehicle Generators

Advertising
This manual is related to the following products: