Grizzly Industrial 10" Heavy Duty Table Saw Model - Manual (Page 23)

G1023S Series Heavy-Duty 10'' Table Saw -21-
Table Insert
Handwheel
Figure 15. Setscrews on each corner of insert.
Figure 14. Tightening handle onto handwheel.
One handwheel has been removed for shipping.
To install, place the handwheel over the threads
and screw the lock knob into the center. Next
insert the handle into the handwheel and tighten
it as shown in
Figure 14 . Install the other handle
onto the other handwheel.
3. Set the table insert into the recessed area on
the table surface.
4. Ensure that all four table insert setscrews
( Figure 15 ) are firmly in contact with the
table casting.
5. Using an allen wrench, raise or lower each of
the four setscrews until the insert is flush
with the table top.
6. Using the side handwheel, position the blade
90° to the table surface.
7. Wearing leather gloves, rotate the blade while
raising and lowering it through its full range of
motion. Make sure it never contacts any part
of the table insert.
8. Repeat Step 6 with the blade in the 45° posi-
tion.
The table insert provides support for the material
being cut. It must be installed flush with the cast
iron table surface.
To install the table insert:
1. Disconnect the machine from the power
source!
2. Using the front handwheel, move the blade
to its lowest position.