Geemarc RP7510 - Manual (Page 8)

5
Setting up
To record a new OGM1
1 Hold down OGM1 - speak after the beep - then release OGM1.
The machine will play your message and ‘A1’ appears.
2 To hear OGM1 at any time, press OGM1.
To record a new OGM2
1 Hold down OGM2 - speak after the beep - then release OGM2.
The machine will play your message and ‘A2’ appears.
2 To hear OGM2 at any time, press OGM2.
• To change your message, just record another.
• If you don’t record a new OGM1, ‘00’ flashes.
Step 5: after how many rings do you want the machine to answer?
There are three settings:
• ‘2’: the machine will answer after 2 rings; or
• ‘4’: the machine answer after 4 rings; or
• ‘t’ (toll saver). If you’re away and ringing in for your messages, toll saver can save you
the cost of a call. It’ll answer after 2 rings if you have any new messages, or after 6
rings if you don’t. So if it rings more than 2 times you can hang up, knowing you have
no messages.
1 Press OGM1.
After the message, ‘2’, ‘4’ or ‘t’ will flash.
2 Press OGM1 again until the setting you want appears.
3 Press STOP.
Step 6 : set the ringer loudness
There are three settings:
• 'LO' : quiet
• 'HI' : loud
•
'OFF' : silent