Grizzly G0654 - Manual (Page 26)

-24-
Model G0654 (Mfg. Since 9/07)
Operation Safety
SEcTION 4: OpERATIONS
To reduce your risk of
serious injury, read this
entire manual BEfORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLy REcOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
figure 36. table control locations.
Basic controls
this section covers the basic controls used during
routine operations.
START Button: starts motor.
STOp paddle: stops motor when pushed in.
figure 35. start/stop controls.
stop
paddle
start
Button
Table Movement: to move the infeed or outfeed
tables, loosen the table locks (see
figure 36),
move the tables with the infeed adjustment lever
or outfeed hand wheel (see
figure 35), then tight-
en the table locks. the depth stop knob locks the
cutting depth at
1 ⁄
8
". to disengage the stop knob,
pull it out and move the infeed table up or down.
infeed
adjustment
lever
outfeed
handwheel
infeed
table lock
depth stop Knob
outfeed table lock