Grizzly G0654 - Manual (Page 44)

-42-
Model G0654 (Mfg. Since 9/07)
To set the 45˚ outward fence stop:
1. pull the plunger out (see figure 74 on page
41).
2. using a sliding bevel adjusted to 135˚, adjust
the fence to the 135˚ (45˚ outward) position,
as shown in
figure 75.
4. adjust the 45˚ outward fence stop bolt until it
makes contact with the back of the fence.
5. retighten the jam nut loosened in Step 3.
Adjusting Gibs
the table gibs eliminate excessive play in the
table movement, and control how easy the tables
move up and down.
Tools Needed Qty
Wrench 10mm ................................................... 1
hex Wrench 3mm .............................................. 1
To adjust the table gibs:
1. using a 10mm wrench, loosen the three
infeed table gib nuts on the back of the jointer
base (see
figure 77).
2. oil the gibs if needed (see page 34).
3. using a 3mm hex wrench, evenly tighten the
gib set screws a small amount, then check
the table by moving it up and down. adjust
the set screws as needed until the friction
of the table movement is balanced between
minimal play and ease of movement.
Note: Tighter gibs reduce play but make it
harder to adjust the tables.
4. repeat Steps 1-3 with the outfeed table, and
oil the outfeed table leadscrew, if needed.
5. set the outfeed table height as described in
Setting Outfeed Table height on page 22.
3. loosen the jam nut on the 45˚ outward fence
stop bolt (see figure 76).
figure 75. example of adjusting fence 45˚ out-
ward.
figure 77. table gib nuts and set screw loca-
tions.
figure 76. 45˚ outward fence stop bolt.
Jam nut
Fence stop Bolt
gib nuts and set screws