Grizzly G0442 - Manual (Page 30)

-28-
Model g0442/g0601 (Mfg since 3/12)
32. slide the reducer over the inlet port on the
barrel ( figure 36), line up the mounting
holes, and secure it in place with the (3) M4 x
12 sheet metal screws.
figure 36. reducer installed.
x 3
reducer
note: The hand-held remote control uses IR
(infrared) to communicate with the control
box receiver port, and must have direct line-
of-sight to the control box face. Locate the
control box with this in mind.
figure 38. switch mounted to stand.
34. Mount the switch on the stand, as shown in
figure 38, with (3) 3 ⁄
8
"-16 x 3 ⁄
4
" hex bolts, (6)
3 ⁄
8
" flat washers, and (3) 3 ⁄
8
"-16 hex nuts.
33. secure the vacuum hose inside the upper
and lower stand legs with the (2) u-shaped
clips (see
figure 37).
figure 37. securing the vacuum hose to the
stand legs.