About this appendix – Genicom LN45 User Manual
Page 200
Publication No. GEG-99126
Genicom
Aug 2001
D-2
GENICOM LN45 and Intelliprint mL450 User Guide
About this Appendix
This appendix lists some of the most frequently-used commands of the
Server command set. More
information about the command set, including additional options, can be found in the Ethernet Network
Interface Manual on the Electronic Library CD-ROM.
Please note the following before continuing:
•
In this command set appendix the NIC is referred to as the Server.
•
Commands are divided into Server (general), Port, and Protocol sections. Within each section, com-
mands are listed alphabetically.
•
Commands may require privileged user status. Enter
Set Privileged
, then enter the privileged pass-
word when prompted.
•
When you enter a Define or Purge command, you must reboot the Server for the command to take
effect.
•
When the abbreviated syntax “
{EN|DIS}
” is shown, you must choose either Enabled or Disabled
to complete the command.
Each section lists additional information needed to use the command table in that section.