Global Machinery Company BJ600 User Manual
Page 5
5
c. Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools.
Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power tools
operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean.
Properly
maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work to be performed.
Use of the power tool for
operations different from those intended could result in a
hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This
will ensure that the safety of the power tool is maintained.
Additional safety rules for biscuit joiners
•
Hold tool by insulated gripping surfaces when performing an
operation where the cutting tools may contact hidden wiring
or its own cord. Contact with a “live” wire will make exposed
metal parts of the tool “live” and shock the operator.
•
Fully unwind cable drum extensions to avoid potential
overheating.
•
When an extension cable is required, you must ensure
that it has the right ampere rating for your power tool
and is in safe electrical condition.
•
Ensure your mains supply voltage is the same as your
tool rating plate voltage.
•
If possible, always use clamps or a vice to hold your work.
•
Always switch off before you put the biscuit joiner down.
•
Ensure that the lighting is adequate.
•
Keep the area free of tripping hazards.
•
Do not let anyone under 18 years operate this tool.
•
Only use accessory blades that are in good condition.
•
Do not touch the blade after operation. It will be hot.
•
Keep yours hands away from under the workpiece.
•
Never use your hands to remove chips or waste close by
the blade.
•
Rags, cloths, cord, string and the like should never be left
around the work area.
•
Support the work properly.
•
Periodically check that all nuts, bolts and other fixings are
properly tightened.
•
When using the tool, use safety equipment including
safety glasses or shield, ear protection, and protective
clothing including safety gloves. Wear a dust mask if the
operation creates dust.
•
If in doubt, do not plug in the tool.
•
Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
Wear goggles
Wear earmuffs
Wear a breathing mask
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.