Global Machinery Company BJ600 - Manual (Page 9)

9
Adjusting the secondary handle
1. Using an Allen key loosen the set screw on each side of
the handle (fig B).
B C
2. Position the handle to the desired position (fig C).
3. Tighten the 2 hex screws to secure the handle in position.
Fitting the height and
bevel adjustment fence
1. Attach the height and bevel
adjustment fence to the main
fence by sliding it over the top
of the main fence (fig D).
Adjusting the bevel angle
The adjustable tilt feature allows
slots to be cut on a bevelled edge.
1. Loosen the bevel adjustment knob (9) by rotating it in an
anti-clockwise direction (fig E).
E F
2. Move the fence to the desired angle between 0° and 90°
using the bevel scale (8) and pointer as
a guide (fig F).
3. Tighten the bevel adjustment
knob (9) to secure the
fence in position (fig G).
Adjusting the cutting
height
The height of the fence can be
adjusted to let you make biscuit
slots at different depths down
from the surface of the workpiece.
1. Ensure that the fence is set at 0°.
2. Position fence (7) to the desired height using the scale
(10) on the main fence as a guide (fig H).
H I
3. Tighten the height adjustment knob (10) by rotating it in a
clockwise direction to secure the fence in position (fig I).
Anti-slip rubber grips
Biscuit jointers tend to pull to the
right when making a cut. The
anti-slip rubber grips have been
provided to reduce this effect
and help keep the biscuit joiner
steady on the workpiece (fig J).
D
J
G