Goldline LOGIC PL-P-4 - Manual (Page 34)

Table of Contents
Introduction Before You Begin................................................................... 1
Installation Steps.................................................................... 2
1. Preparing General Water Chemistry..................................................... 2
Pool/Spa Water Salt.......................................................................................... 3
2. Mounting Pro Logic Control Center....................................................... 5
Equipment Temperature Sensors............................................................. 5
Optional Chlorination .............................................................. 5
Optional AQL-CHEM Sensing Kit......................................... 5
Optional AQL-CHEM2 CO
2
Dispense Kit............................ 6
Optional Remote Controls..................................................... 6
Optional Base Station............................................................ 7
Optional Valve Actuators........................................................ 7
3. Plumbing Pool/Spa Configuration.......................................................... 8
Turbo Cell.................................................................................... 9
Flow Switch............................................................................. 9
4. Electrical Main Service........................................................................... 10
Wiring Grounding and Bonding......................................................... 10
Circuit Breaker Installation and Wiring.................................. 10
General Purpose Outlet........................................................... 11
Pro Logic Control Power....................................................... 11
High Voltage Pool Equipment............................................... 11
Low Voltage Wiring................................................................ 13
5. Configuration Configuration Menu................................................................ 20
6. System Startup Before Startup........................................................................ 30
and Checkout Heater Checkout.................................................................... 30
Service Mode......................................................................... 31
7. Warranty Pro Logic Limited Warranty...................................................32
31
• The display will periodically indicate that the filter pump is on for heater cooldown and show the minutes
remaining.
• The pump will automatically turn off at the end of the 5 minute heater cooldown period.
For more detailed instructions on control and operation of the Pro Logic system, refer to the Operation Manual.
Service Mode
Service mode disables all automatic control operation and is intended to be used when servicing the pool system. To
enter service mode, push the SERVICE button once on the main unit keypad. This will initially turn all outputs off and
then allow you to turn outputs on/off manually at the main display (only). In service mode, the buttons on the optional
remote display/keypad and the optional spa side remote will turn outputs off, but will not turn any output on. Heater
control outputs and solar control outputs are prevented from turning on if the water temperature exceeds 104ºF
(40ºC).
Pushing the SERVICE button again will enter a timed service mode. Service operation as described above will
continue for 3 hours, then automatically return to normal operation.
Push the SERVICE button once more to exit out of Service mode.