Installation – Geemarc TP38 User Manual
Page 2
2
1. INSTALLATION
1.1 To Install the Batteries
Batteries are required for the Caller ID function and telephone operation of the unit.
To open the battery door and install the batteries, follow the procedure below :
1. Open the battery door by pulling back the latch.
2. Insert four (4) AAA alkaline batteries into the battery compartment.
3. Snap the battery door back into place.
The display will show “12:00 01/12” and “CALLS:00 NEW:00” which means both
the Total Call and New Call counter are Zero.
When the first call comes in, the time and date are automatically set from the Caller
ID information provided by your phone company.
Note:
• The speakerphone will not work if the batteries are not fitted.
• This unit will signal you when the batteries become weak and need replacement.
Once battery power has been sufficiently drained, the battery low icon will be lit
on the display. Replace the AAA batteries with four (4) fresh ones to make the
unit working properly.
1.2 Connecting the telephone
1. Plug one end of the telephone line cord into the jack marked LINE on the bottom
of the unit.
2. Plug the other end of the telephone line cord into the wall outlet.
3. Plug one end of the coil cord into the jack marked HANDSET on the bottom of
the unit.
4. Plug the other end of the coil cord into the jack of the handset.
1.3 Fitting the desk Support
If you intend to use your telephone on a desk, then the desk support supplied must
be fitted. To do this, turn the telephone over. Now insert the two upper hooks into the
openings provided and push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the upper
edge and then pull the desk support off.