GE WineChiller - Manual (Page 9)

9
Reversing the Door.
ge.com
Consumer Support
Tr
oubleshooting T
ips
Operating
Instructions
Safety Instructions
Installation Instructions
Care and Cleaning
Unplug the wine chiller.
Remove the two screws at the back of the top cover.
Lift the back of the cover up about 2
″ (5 cm) and then slide it
forward slightly, but do not remove.
Tilt the top cover on its side. Locate the power connectors at the
front of the cover. Disconnect each connector by pressing in on
the locking tab on the side of the connector, then pulling out.
Set cover aside.
Carefully lay the wine chiller on its back.
Remove the screws on the top hinge (right side). Remove the hinge.
On the opposite side, remove the screws attaching the top plate to
the cabinet, and install them in the holes left vacant by the top
hinge screws.
Remove the small plug button from the top left side of the door and
install it in the hole on the right side.
Insert the hinge pin from the top hinge into the hole on the top left
side of the door. Attach the top hinge to the cabinet with the screws.
Make sure the door is aligned with the wine chiller cabinet before
tightening the screws.
Top cover
Remove screws
Back of wine chiller
Top cover
Disconnect power
connectors
Remove screws and
top hinge, and move
to other side
Remove screws and
move to other side
Remove plug button and
move to other side
Front of wine chiller
Top of wine chiller