Graco MAGNUM 261800 - Manual (Page 18)

Rolling
18 312079A
Rolling
Setup
• Before assembling roller, follow Priming
instructions, beginning on page 9 for Hopper
Method or page 12 for Immersion Method.
• After priming, only paint should come out of
spray gun. Water in hose line will cause paint to
run.
1. Set AllControl to lowest
ROLL setting.
2. If installed, remove tip and
guard assembly from gun.
3. Make sure gasket is in
place in bottom of roller
frame.
4. Rest roller on flat surface
and align gun with roller.
Tighten nut with wrench
while keeping gun and
roller aligned.
5. Unlock gun trigger safety. Trig-
ger gun. Roll surface until paint
is fully dispersed on roller. This
may take a minute.
6. Increase pressure only if triggering gun does
not supply enough paint for your rolling speed.
7. Whenever you stop painting, relieve pressure,
page 7 and elevate roller end of extension tube
to prevent paint from draining out.
8. Flush the pump, gun and pressure roller imme-
diately after each use to prevent paint from dry-
ing in the pressure roller and damaging it. See
Shutdown and Cleaning, beginning on page 20.
ti9170a
ti9339a
ti9650a
• Trigger gun briefly only when you need
more paint.
• For best operating pressure set AllControl
to the lowest ROLLER setting which
provides an even paint supply to the roller.
ti8922a