Operating – Great Dane Chariot Brutus GBKW2552S User Manual

Page 16

Advertising
background image

Operating - 14

OPERATING

NOTE: The rear anti-scalp wheels are located under the rear of the
mower deck.

4.Adjust anti-scalp wheel (A) to one of two positions (B).

• Remove screw (C), nut and washer.

• Adjust wheel up or down so it is approximately 6-13 mm (1/4-1/2 in.)
above mowing surface.

5.Install wheel with attaching hardware.

6.Adjust all wheels to same height.

Testing Safety Systems

The safety systems installed on your machine should be checked before
each machine use. Be sure you have read the machine operator manual
and are completely familiar with the operation of the machine before
performing these safety system checks.

Use the following checkout procedures to check for normal operation of
machine.

If there is a malfunction during one of these procedures, do not operate
machine. See your authorized dealer for service.

Perform these tests in a clear open area. Keep bystanders away.

Testing Safety Systems

The safety systems installed on your machine should be checked before
each machine use. Be sure you have read the machine operator manual
and are completely familiar with the operation of the machine before
performing these safety system checks.

Use the following checkout procedures to check for normal operation of
machine.

If there is a malfunction during one of these procedures, do not operate
machine. See your authorized dealer for service.

Perform these tests in a clear open area. Keep bystanders away.

Testing PTO Switch

1.Sit on the operator seat with the motion control levers in the neutral
detent position (standard levers) or neutral lock position (optional “over the
lap” levers).

2.Lock the park brake.

3.Pull PTO knob up to engage.

4.Turn key switch to the start position.

Result: The engine must not crank.

Testing Park Brake Switch

1.Sit on the operator seat with the motion control levers in the neutral
detent position (standard levers) or neutral lock position (optional “over the
lap” levers).

2.Push PTO knob down to disengage.

3.Unlock the park brake.

4.Turn key switch to the start position.

Result: The engine must not crank.

Testing Neutral Start Switch

NOTE: Repeat this test three times, with the motion control levers in
the following positions:

• Right side motion control lever inward.

• Left side motion control lever inward.

• Both motion control levers inward.

1.Move motion control lever(s) out of the neutral detent position (standard
levers) or neutral lock position (optional “over the lap” levers).

2.Lock the park brake.

3.Push PTO knob down to disengage.

4.Turn key switch to the start position.

Result: The engine must not crank.

CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.

Move the machine to an outside area before running the
engine.Do not run an engine in an enclosed area without
adequate ventilation.•

•Connect a pipe extension to the engine exhaust pipe to
direct the exhaust fumes out of the area.

•Allow fresh outside air into the work area to clear the
exhaust fumes out.

CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.

Move the machine to an outside area before running the
engine.Do not run an engine in an enclosed area without
adequate ventilation.•

•Connect a pipe extension to the engine exhaust pipe to
direct the exhaust fumes out of the area.

•Allow fresh outside air into the work area to clear the
exhaust fumes out.

Advertising
This manual is related to the following products: