Great Dane Chariot Brutus GBKW2552S - Manual (Page 51)

Assembly - 49
ASSEMBLY
1.Remove and retain the two locknuts and cap screws securing the
flanges at the rear of the seat frame to the machine.
2.Pivot seat frame (A) forward until it rests on the hinge stops.
3.Remove and retain the seat pivot shoulder bolts (B) and nuts.
4.Remove protective covers from seat screws.
NOTE: The seat mounting hardware is attached to the seat plate with
tie straps.
5.Install seat (C) to the seat frame (A), using four 5/16-18 locknuts and
heavy flat washers (D). Tighten locknuts to 27 N•m (20 lb-ft).
6.Connect wire harness to seat safety switch (E).
7.Secure front of seat frame to machine with seat pivot shoulder bolts and
nuts, removed earlier. Tighten to 81 N•m (60 lb-ft).
8.Secure rear of seat frame to machine with capscrews and locknuts,
removed earlier.
Install ROPS
1.Support rear of bumper with wooden blocks or jack.
2.Loosen nut (A) securing the rear battery hold-down rod and disengage
hooked end (B) from bumper.
3.Remove all bumper mounting bolts and retaining hardware except for
the lower left cap screw (C) at each side of the machine. Discard any
assembly washers, retain bolts and locknuts for later use.
4.Fold ROPS to the upright operating position and install lock pins (D) and
spring pins (E).