GIGABYTE GA-8IDML - Manual (Page 23)

19
Hardw are Installation Process
L : CD_IN
N: F_AUDIO Connector
K :WOL
1
+5V SB
GND
Signal
E / F : Floppy / IDE1 / IDE2 Connector
IDE2
1
IDE1
1
Floppy
1
GND
1
CD-L CD-R
Incase Speaker (L)
GND
GND
GND
Rear Audio(R)
Rear Audio(L)
Incase Speaker (R)
GND
+12V
MIC
GND
GND
Front Audio(R)
Front Audio(L)
1
There are two types of Front Audio connector, please refer to the tables below before you install.
? If you want to use ty pe-1 Front Audio connector, you must remov e 11-12,13-14 Jumper.
If you want to use type-2 Front Audio connector, you must remove 3-4 ,5-6 Jumper. In order to
utilize the front audio header, your chassis must have front audio connector. Also please make sure
the pin assigment on the cable is the same as the pin assigment on the MB header. To find out
if the chassis you are buying support front audio connector, please contact your dealer.
Type 2 Type 1
GND
Rear Audio (L)
MIC
Front Audio (R)
GND
1
Rear Audio (R)
Front Audio (L)