GIGABYTE GA-8IDML - Manual (Page 43)

BIOS Setup
39
Parallel Port Mode
SPP Using Parallel port as Standard Parallel Port. (Default Value)
EPP Using Parallel port as Enhanced Parallel Port.
ECP Using Parallel port as Extended Capabilities Port.
ECP+EPP Using Parallel port as ECP & EPP mode.
Parall el Port EPP Type
EPP 1.9 EPP Version is 1.9. (Default value)
EPP 1.7 EPP Version is 1.7.
AC Back Function
Memory System power on depends on the status before AC lost.
Soft-Off Always in Off state when AC back. (Default value)
Full-On Always power on the system when AC back.
OnBoard Par allel port
378/IRQ7 Enable On Board LPT port and address is 378.(Default Value)
278/IRQ5 Enable On Board LPT port and address is 278.
3BC/IRQ7 Enable On Board LPT port and address is 3BC.
Use IR Pins
IR-Rx2Tx2 Enable On Board LPT port and address is 378.(Default Value)
RxD2,TxD2 Enable On Board LPT port and address is 278.