Epson CX11NF - Manual (Page 75)

Accessing the Setup Menu
75
USB Menu
These settings control communication between the CX11N and the computer when
they are connected using a USB interface. Some items may not appear unless
corresponding devices are installed.
After these settings are changed, the new settings don’t take effect until after a reset or
after the power is turned off and on again, even though it is shown on the Status
Sheet.
Network Menu
These settings control communication with the CX11N when it is connected to a
computer network.
Item Settings
USB I/F On, Off
USB Speed HS, FS
Item Settings
Network I/F On, Off
Network Config No, Yes
If Yes is selected then Get IPAddress, IP, SM GW,
Appletalk, MS Network, Rendezvous, and Link Speed appear
as available settings in the Network menu.
Get IPAddress Panel, Auto, PING
IP (IP address)* 0.0.0.0 to 255.255.255.255
SM (Subnet mask) 0.0.0.0 to 255.255.255.255
GW (Gateway address) 0.0.0.0 to 255.255.255.255
AppleTalk On, Off
MS Network On, Off
Rendezvous On, Off
Link Speed Auto, 100 Full, 100 Half, 10 Full, 10 Half