Golden Technologies GB 101 - Manual (Page 21)

Buzzaround Owner’s Manual - Updated 092605
Page 21
GENERAL CARE AND MAINTENANCE
Wheels and Tires
Your Buzzaround
™ scooter is equipped with “split-rim” wheels and foam-filled
tires.
Front Tire Rear Tire
Foam-Filled Foam-Filled
How to change a tire assembly:
1. Remove the center nut.
2. Remove the tire assembly from the scooter
3. Install a new tire assembly onto the axle.
4. Install and tighten the center nut.
NOTE: All tires on your Buzzaround are foam-filled. This means that there is
NO air in any tire. The tires are filled with foam. This means you will never have
a flat tire even if you puncture the tire.
IF YOUR BUZZAROUND DOES NOT OPERATE
• Make certain that the brake handle is set to the engaged (forward)
position.
• Check the main circuit breaker. If necessary, reset the circuit breaker.
• Make certain that the speed adjustment dial is at the desired setting.
• Be sure that the key is all the way in the key receptacle and the scooter is
“ON” (note the green “LED” light is illuminated)
IF NONE OF THE ABOVE PROCEDURES SOLVE THE PROBLEM, CONTACT
YOUR AUTHORIZED GOLDEN TECHNOLOGIES DEALER.
LUBRICATION
All of the bearings on your Golden Buzzaround are permanently lubricated and
sealed.
• No lubrication is required.