Go-Video R6530 - Manual (Page 31)

31
Basic
Set
u
p
G
etting
Sta
rted
DVD
Recording
DVD
Playb
a
ck
Ad
vanc
e
d
Se
tti
n
gs
He
lp
Chapter 4
DVD Playback
:: Basic Disc Playback
Playing a DVD
Before you begin:
• Turn on the DVD player using the front panel Power button. If the unit is in Standby mode, press On/Standby on the remote control to power
on the unit. The green Power indicator will glow on the front panel display.
• Turn on your TV, and set it to the video input connected to the DVD player.
• Turn on your audio system (if using an external amplifier/audio system), and set it to the input connected to the DVD player.
1 Press Open/Close on the remote control or front panel to open the disc drawer.
2 Place the disc in the drawer with the label side facing up and playback side facing down. If the disc has two sides, place the disc with the
desired playback side facing down.
3 Press Open/Close again to close the disc drawer.
4 Press Play /Enter on the remote control or front panel.
• Many discs will load and begin playing automatically when the disc drawer closes. Most rental DVDs have disc menus to aid in naviga-
tion; see “Disc Menu Navigation” on page 33.
• If the disc is a DVD+R/+RW, the disc menu will appear; see “About R6530 Disc Menus” on page 32.
• If the disc is scratched, dirty, or not encoded for Region 1, you will receive an error message and the disc will not play.
• Always press Stop to stop playback of a disc before powering off the player.