GE ProBridge PBe - Manual (Page 13)

9
Installation overview
The basic steps required to install the PBe are:
1. Physically connect the PBe interface to the network
switch or hub and the DVR using the supplied cables.
2. Program monitor mode to on by setting SW1 switches 1
to 4. See SW1 switches 1 to 4 on page 20 for the switch
settings.
3. Program the camera number to be associated with the
ATM’s transaction data to the PBe. See SW1 switches 5
to 8 on page 21.
4. Program the DVR to record in the way desired for your
specific site.
Required information
The following information is required for a successful PBe
installation. This information is used to configure the PBe. You
will need to contact the customer’s ATM network administrator
for answers to these questions.
Ethernet device type
• Generic interface
• Native ATM messages (FC)
• Verifone POS
• Ethernet data analyzer