Gefen EXT-COMPAUD-CAT5-444 - Manual (Page 10)

7
1 Component With Audio Extension Input
Connect the included jumper cables between the Component With Audio
Outputs (Item 5 on this page) and these inputs. Inputs include component video,
analog audio, and digital audio connectors. There are 4 inputs that are used in
conjunction with the CAT-5 output ports for extension.
2 IR Blaster Outputs
Connect IR emitters/blaster (sold separately, Gefen Part # EXT-2IREMIT) to
these output ports. Each output is linked to one of the extension receivers. IR
information is relayed from each remote location and is sent to these blasters for
control of local equipment from the extended location. Place the blaster “eye” on
or near the IR receiver of the connected equipment.
3 CAT-5 Extension Ports
Connect user supplied CAT-5e cables between these ports and the 4x4
Component Audio Over CAT-5 Receivers at remote locations. These cables
will transmit the component and audio signals to the remote locations while
receiving IR data from each receiver.
4 RS-232 Serial Control Interface
This port is used for control of the 4x4 Component Audio Over CAT-5 by RS-232
serial communication. Please see page 18 for more information.
5 Component With Audio Outputs
Connect the included jumper cables between the Component With Audio
Extension inputs (Item 1 on this page) and these inputs. Outputs include
component video, analog audio, and digital audio connectors. There are 4
outputs.
6 Component With Audio Inputs
Connect the component video and audio source devices to these input ports
using the supplied component and audio cables. Up to 4 sources can be
connected at one time. Inputs include component video, analog audio, and
digital coaxial connectors.
7 24V DV Power Input
Connect the included 24V DC power supply to this input.
4X4 COMPONENT MATRIX OVER CAT-5 BACK
PANEL DESCRIPTIONS