Gefen EXT-COMPAUD-CAT5-444 - Manual (Page 19)

16
Each extended location with a 4x4 Component Matrix Over CAT-5 Receiver can use
an RMT-4IR remote control to choose which source will be viewed by the attached
display. Pressing the numbered buttons will switch to the source connected to the
same numbered input on the 4x4 Component Matrix Over CAT-5.
To use the RMT-4IR remote, remove the battery cover on the back of the remote
to reveal the battery compartment (see page 14 for a picture). Insert the included
battery into the open battery slot. The positive (+) should be facing up. Ensure that
the both dip switches are in the OFF position. Replace the battery cover.
The remote ships with 2 batteries. One battery is required for operation and the other
battery is a spare.
LED Indicator
Input Selection
Buttons
RMT-4IR REMOTE CONTROL INSTALLATION