Generac 11400 - Manual (Page 4)

Generac Portable Products PP5000T Generator
4
120 Volt AC, 20 Amp Receptacles — May be used
to supply electrical power for the operation of 120 Volt
AC, 20 Amp, single phase, 60 Hz electrical lighting,
appliance, tool and motor loads.
120 Volt AC, 30 Amp Locking Receptacle — May
be used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
120/240 Volt AC, 20 Amp Locking Receptacle —
May be used to supply electrical power for the
operation of 120 and/or 240 Volt AC, 20 Amp, single
phase, 60 Hz AC electrical lighting, appliance, tool
and motor loads.
Air Filter — This engine assembly filters air entering
the engine.
Circuit Breakers (AC) — Each receptacle is
provided with a circuit breaker to protect the
generator against electrical overload. Breakers are
"push to reset" type.
Fuel Shut Off Valve — Controls fuel supply to
engine.
Fuel Tank — Capacity of 4 U.S. gallons.
Grounding Wing Nut — Provides a tie-point for
connecting the generator frame to earth ground.
Run/Stop Switch — Must be in “Run” position to start
engine. Set to “Stop” to stop a running engine.
SPECIFICATIONS
Rated Maximum Continuous
Wattage Capacity 5000 Watts
Power Factor 1.0
Rated Maximum Continuous Load Current
At 120 Volts 41.67 Amps
At 240 Volts 20.83 Amps
Phase 1-phase
Rated Frequency 60 Hertz
KNOW YOUR GENERATOR
Read this owner’s manual and safety rules before operating your generator.
Compare the illustrations with your generator to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
Circuit Breakers (AC)
Fuel Tank
120 Volt AC, 30 Amp
Locking Receptacle
Run/Stop Switch
Air Filter
120/240 Volt AC, 20 Amp
Locking Receptacle
120 Volt AC, 20 Amp
Receptacles
Grounding Wing Nut
Fuel Shut–Off Valve