GE ZET2 - Manual (Page 8)

8
Cabinetry
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior 23 1/2
”
(59.7 cm) depth and 9 1/4 ” (23.5 cm) height.
• These Monogram Ovens require 3/4 ” (1.9
cm) overlap on both sides. Allow 1 ” (2.5 cm)
Min. for top overlap and clearance to upper
doors.
• The Monogram Warming Drawers require
5/8 ” (1.6 cm) overlap on all sides.
• When installing a Monogram Warming
Drawer below a single or double oven, a
separate 120V, 60 Hz, properly grounded
receptacle must be installed. Refer to
installation instructions packed with the
Warming Drawer for specific installation
requirements.
Frameless Cabinets
Whenever possible, order 30 ” (76.2 cm)
frameless cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional
finished filler pieces may be required to
cover the opening.
• A stock frameless cabinet cutout width
may be up to 28 3/4 ” (73 cm). If necessary,
add 1/2 ” (1.3 cm) cleats to the sides, flush
with the front edge of the side panels to
accept mounting screws.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
Cutout for Frameless Cabinets
A6
Single Oven Cutout
for Installation Over
a Monogram Warming
Drawer
A4 Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
A5
27 5/16 ”
(69.2 cm)
Max.
23 1/2 ”
(59.7 cm)
Min.
Inside
2 ” x 2 ” (5 cm x 5 cm) or
2 ” x 4 ” (5 cm x 10 cm)
Anti-Tip Block Against
Rear Wall, 9
” (22.9 cm)
From Floor to Bottom
of Block
2 ” (5.1 cm)
Min.
Allow 5/8 ”
(1.5 cm)
Overlap
on All
Sides
1 ” (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
9 ” (22.9 cm)
Max.
28 1/2 ”
(72.4 cm).
51 15/16 ”
(131.8 cm)
Max.
23 1/2 ”
(59.7 cm)
Min.
Inside
2 ” x 2 ” (5 cm x
5 cm) or 2 ” x
4 ” (5 cm x 10
cm) Anti-Tip
Block Against
Rear Wall, 9
”
(22.9 cm)
From Floor
to Bottom
of Block
2 ” (5.1 cm)
Min.
Allow 5/8 ”
(1.5 cm)
Overlap
on All
Sides
1 ” (2.5 cm) Min. Above Toekick
9 ” (22.9 cm)
Max.
28 1/2 ”
(72.4 cm)
Cabinet Depth
23 1/2
” (59.7 cm)
Min. From Inside
Back to Front of
Cabinet Frame
or Side Panel
3/4 ” (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush
with Front of
Side Panel
Install 1/2 ”
(1.3 cm)
Cleats to
Hold Oven
Mounting
Screws
30 ”
(76.2 cm)
28 1/2 ” (72.4 cm)
Min.
28 5/8 ” (72.7 cm)
Max. Double
51 15/16
” (131.8 cm)
Single
27 5/16
” (69.2 cm)
9 1/4 ”
(23.5 cm).
9 1/4 ”
(23.5 cm).