Grizzly G5954 - Manual (Page 14)

-12-
G5954 5HP Dust Collector
Base and Motor/Fan
Components and Hardware Needed: Qty
Base .................................................................. 1
Casters .............................................................. 4
Flange Bolts
5 ⁄
16
-18 x 1 ⁄
2
" ................................. 32
Stand Legs ........................................................ 4
Motor/Fan Assembly ......................................... 1
To assemble the base:
1. Attach each caster to the underside of the
base using four 5 ⁄
16
-18 x 1 ⁄
2
" hex bolts.
2. Attach each leg to the underside of the fan/
motor assembly using two 5 ⁄
16
-18 x 1 ⁄
2
" flange
bolts, as shown in Figure 5.
Figure 5. Attaching legs to motor/fan assembly.
3. Attach the base to the legs using eight 5 ⁄
16
-18
x 1 ⁄
2
" flange bolts, as shown in Figure 6.
Figure 7. Mounting collectors to motor/fan
assembly.
Components and Hardware Needed: Qty
Gasket ............................................................... 1
Collector ............................................................ 1
Flange Bolts
3 ⁄
8
-16 x 1 1 ⁄
4
" ................................... 8
Hex Nuts 3 ⁄
8
-16 .................................................. 8
Flat Washers 3 ⁄
8
............................................... 16
4-in-1 Inlet Adapter ............................................ 1
Base/Motor/Fan Assembly ................................ 1
To attach the collectors to the motor/fan
assembly:
1. Fit the gasket onto the outtake of the motor/
fan assembly.
2. Mount the collector to the motor/fan assem-
bly using the flange bolts, flat washers and
hex nuts, as shown in
Figure 7.
Collector
Figure 6. Attaching base to legs.
4. Turn the motor/base assembly right-side up
and place carefully onto the floor.