Grizzly G9731 - Manual (Page 65)

BdYZa<.,(%$<.,(& B[\#H^cXZ.$%%
"*,"
4.  HZi i]Z fj^X` X]Vc\Z `cdWh Vh h]dlc ^c
Figure 84 #
 Note: Keep in mind the spindle must be
completely stopped before using the quick
change knob A–C on the headstock.
5. GdiViZ i]Z [ZZY hZaZXi^dc `cdW dc i]Z fj^X`
X]Vc\Z \ZVgWdm id i]Z aZ[i id hZaZXi i]Z
aZVYhXgZl[dgedlZgZYbdkZbZci#
Figure 84. Fj^X`X]Vc\Z`cdWhXdc[^\jgZY[dg
&&IE>i]gZVY^c\#
&&IE>
;ZZY
HZaZXi^dc
@cdW
Halfnut Lever
I]Z ]Va[cji aZkZg Zc\V\Zh i]Z XVgg^V\Z l^i] i]Z
aZVYhXgZll]^X]bdkZhi]ZXjii^c\iddaVadc\i]Z
aZc\i] d[ i]Z ldg`e^ZXZ [dg i]gZVY^c\ deZgVi^dch
hZZFigure 85 #
7Z[dgZViiZbei^c\idejh]i]Z]Va[cjiaZkZgYdlc
idZc\V\Zi]Z]Va[cjil^i]i]ZaZVYhXgZl!ValVnh
bV`ZhjgZi]Z[ZZYDC$D;;`cdW^hejh]ZY^chd
i]Vii]ZXVgg^V\Z^hcdiZc\V\ZYl^i]i]Z[ZZYgdY#
NOTICE
Even though there is a lock-out device in
the apron to prevent the feed control knob
and the halfnut lever from being engaged
at the same time, this lock-out device could
break with enough force. If you attempt
to engage the feed control knob and the
halfnut lever at the same time, severe lathe
damage could result and will void the war-
ranty.
Figure 85. AdXVi^dcd[i]Z]Va[cjiaZkZg#
=Va[cjiAZkZg
;ZZYDC$D;;@cdW