Grizzly 14.4v 3/8" Cordless Drill G8594 - Manual (Page 7)

G8594 14.4V Cordless Set -7 -
DRILL OPERATION
Inserting Battery Into Drill
1. Insert the battery into the handle of
the drill so that the long end is for-
ward. The battery will only install in
one orientation.
2. Make sure the securing clasps on
either side of the drill base engage
with the clips on the battery compart-
ment.
Inserting and Removing Bits and
Drivers:
1. Set the direction switch, located just
above the trigger, so that it is in the
center position.
2. Hold the chuck by the collar while
turning the sleeve (the forward sec-
tion). See Figure 1. This will cause
the three chuck jaws located inside
the recess to open or close depend-
ing upon the direction.
3. When the jaws are at the approximate
diameter of the bit or driver, insert the
shank end of the bit or driver into the
jaw opening.
4. Turn the sleeve clockwise until it tight-
ens around the bit or driver. Never
“power tighten” which is holding the
sleeve while running the drill. This
can cause a loose grip on the bit or
driver and potential damage to chuck
jaws. Check for tightness periodically
while using the tool.
5. To release the bit or driver, hold the
chuck collar, and turn the sleeve
counterclockwise.
Operating this equipment has the
potential to propel debris into the air
which can cause eye injury. Always
wear safety glasses or goggles when
operating equipment. Be certain the
safety glasses you wear meet the
appropriate standards of the
American National Standards
Institute (ANSI).
Fig 1. Inserting bits into the chuck.