Global Machinery Company DEC004DC - Manual (Page 15)

15
3. Loosen the shaft by turning anti-clockwise (as indicated
on the shaft). Extend the shaft to the desired height and
lock it into place by turning the shaft clock-wise (fig. Q).
4. Use the wire loop (8) to hang the rotary tool when using
the flexible shaft. (fig. R)
Maintenance
Store the machine, instruction manual and, where
necessary, the accessories in the original packaging. In this
way you will always have all the information and parts ready
on hand.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a rag.
3. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool.
Repairs
1. Only an authorised service centre should replace the
cordset or effect other repairs. If the cordset is damaged
or worn, have it repaired or replaced by an authorised
service centre.
2. When the brushes are worn, the tool may not work. Have
new brushes fitted by an authorised service centre.
Please refer to your warranty card, which is separate to
these instructions
Q R