Graco PD135573A - Manual (Page 11)


To select your preferred mode:
2.
Turn off the thermometer. Press the
Mode button and release. Cycle through the
4 modes by pressing the Mode button until
you find your preferred mode.
Each mode will point to a different body
part and the stand by icon will display the
full body as shown below. After 8 seconds
the thermometer will enter the “ready for
measuring mode automatically, or you can
turn off the thermometer and turn it back
on again and you will hear a beep, the
thermometer will flash all of the display icons.
NOTE: After the first use, the prior
reading and a figure indicating the last
measurement method will automatically
appear for 2 seconds. Each time you turn the
thermometer on, it will automatically default
to the same method as the prior reading.