Gefen CAT-5 4000 - Manual (Page 5)

READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE CAT5•4000 EXTENDER
• Maximum distance ratings:
• VGA 1920x1200 60Hz is 330 feet.
• DVI 1920x1200 60Hz is 130 feet.
• DVI 1280x1024 60Hz is 300 feet.
• VGA Supported resolutions: 640 x 480 through 1920 x 1200
• DVI Supported resolutions: 640 x 480 through 1920 x 1080
• The CAT5•4000 Extender can send only one video type, either analog or
digital, from each input. While the DVI-I input can accept both types, please
ensure that only one type of signal is being used by using either a DVI-A or
DVI-D cable.
• The channel 1 video input will be mirrored to two separate outputs on the
CAT5•4000 sender unit. However, two separate RS-232 inputs are provided
and will accommodate an individual RS-232 device for each of the two
mirrored video outputs.
• Analog stereo audio connected via the 3.5mm mini-stereo input jack will be
transmitted through the mirrored outputs on channel 1 only.
• Channels two and three do not support audio extension.
• Channels two and three have individual RS-232 connections for use.
• When analog video is used on channels two and three, only a single CAT-5,
CAT-5e or CAT-6 will be required for full video and RS-232 extension. When
digital video is being used, two CAT-5, CAT-5e or CAT-6 cables will be
required for full video and RS-232 support.
• When analog or digital video is used on channel one (this applies to either
of the mirrored outputs), two CAT-5, CAT-5e or CAT-6 cables will be required
for full video, audio, and RS-232 support.
• The CAT5•4000 receiver units need to be confi gured for use on either
channel 1 (dual outputs) or for use on channels 2 and 3. There is a
DIP (Dual In-line Package) switch bank located on the underside of the
CAT5•4000 receiver that will set the unit for proper operation for either
channel 1 (both outputs) or for channels 2 or 3. Please see page 14 for
details on how to change these DIP switches.
2
OPERATION NOTES