GTO SL-1000B - Manual (Page 14)

12
S
INGLE
G
ATE
O
PERATOR
I
NSTALLATION
O
VERVIEW OF
O
PERATOR
I
NSTALLATION
G
ATE
P
REPARATION
Level
Plumb
Concrete
Concrete
Be sure the gate is properly installed and slides smoothly before installing the GTO/PRO Slide Gate Operator. The
gate must be plumb, level, and move freely. The gate must not bind or drag on the ground. Never use a wheel
on the gate, because the additional drag and resistance can cause the operator to obstruct.
The diagram below shows a single slide gate installation with recommended safety features. The operator must
be installed on the inside of the gate. GTO requires using safety edges and roller guards to help reduce the
possibility of bodily injury.
Chain
Contact Sensor
Roller Guard
Receiver
(cable in separate
conduit)
Roller Guard
CAUTION AUTOMATIC GATE STAND CLEAR 1-800-543-GATE
®
Operator
Contact Sensor
Contact Sensor
(REQUIRED)
(REQUIRED)
(REQUIRED)
(REQUIRED) (REQUIRED)
Use PVC Conduit
(not included)
Run 1000' (max.) of low
voltage wire to control
box from transformer
(wire not included).
120 Volt Indoor
Transformer
(Surge Protector
not supplied)
Roller Guard
(REQUIRED)
Chain Bracket
Chain Bracket
for power cables.
1. KEEP CLEAR! Gate may move at any time. 2. Do not allow children to operate gate or play in gate area. 3. This gate is for vehicles only. Pedestrians must use a separate entrance.
Moving Gate Can Cause Injury Or Death
WARNING !