Global Machinery Company MAG950HD - Manual (Page 9)

9
Operation
Starting and stopping
1. Plug the cordset into the
mains socket.
2. Depress the on/off trigger
switch (1) to start the drill and
release the trigger when you
wish to stop (Fig. H).
Variable speed
1. The speed of the drill can be adjusted using the variable
speed dial (8).
2. To increase the speed, turn the dial clockwise (Fig. I).
3. To decrease the speed, turn the dial anti-clockwise (Fig. J).
I J
4. Selecting the speed enables the user to have greater control
of the tool and allows drilling in a variety of materials.
Note. The speed can be changed while the drill is running.
Forward/reverse
1. The forward/reverse lever switch (4) is located
immediately above the trigger switch (1).
2. It determines the direction of
rotation of the tool and serves
as a lock off control.
3. To select forward rotation,
release the trigger switch and
push the forward/reverse lever
switch to the left side of the tool
(Fig. K).
4. To select reverse, push the forward/reverse lever switch
(4) to the right side of the tool (Fig. L).
5. When the switch (4) is left in middle position, it locks the
motor (Fig. M).
L M
WARNING. When changing the position of the switch (4) be
sure the trigger is released and the motor is stationary. Any
attempt to reverse the direction of rotation whilst the drill is
turning is likely to permanently damage the switch.
Note. The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Lock on button
1. The lock on button (2) maintains the speed of the motor
without having to hold the trigger switch (1) depressed.
2. If you require continuous operation, press the lock-on
button (2) whilst the trigger switch is depressed (Fig. N).
3. To disengage the lock-on button, press the trigger switch
(Fig. 0).
N O
K
H