GE ZPBS360 - Manual (Page 2)

INSTALL GRILLE PANEL
• Remove the protective film from the appearance panel.
• Raise the grille panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If installing Stainless steel panels, first slide the filler panel
into the trim, then slide the stainless panel into the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
STEP 3
31-46149
224D1889P009
06-08 JR
Note: Product improvement is a continuing endeavor at General Electric.
Therefore, materials, appearance and specifications are subject to change
without notice.
GE Consumer & Industrial
Appliances
General Electric Company
Louisville, KY 40225
ge.com
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
Adjust Nut Below
Spring to Accommodate
Panel Weight