Garmin HN294DP/DI - Manual (Page 64)

Advanced Configuration
58 EN/LZT 108 6377 R4 - September 2003
Parameter Description
VCI Identifies the VCI (Virtual Channel Identifier). The
valid range is from 32 to 4095 (1 to 31 are reserved
for well-known protocols).
ATM Service Type Supported ATM Service Types are UBR, CBR,
VBR-nrt and VBR-rt.
PCR (Peak Cell Rate) Identifies the PCR cells per second. Valid values are
min. 10 and max 2500.
Encapsulation Type Supported Encapsulation Types are VC-MUX or
LLC/SNAP.
IP Configuration
Local WAN IP Address In Router mode, selecting None means that you
have a public LAN IP address.
If you select Specify an IP Address, you can
specify a WAN IP address provided by your
ISP/service provider for your HN294d.
If Server assigned IP Address is selected, the
HN294d will get a dynamic WAN IP address when
connecting to the remote server or ISP.
NOTE! If a fixed WAN IP is entered, this IP address
and the subnet mask MUST NOT be the same as
the public LAN interface.
PPP Configuration:
User Name/Password The User Name and Password used to access the
remote server or ISP.
Service Name The name of your PPP service.
Service Server
Session established by Check Dial on Demand if you want the HN294d to
automatically dial the ISP when any client PC sends
out a request for connection. In this case, you can
disconnect the PPP session by clicking the
Disconnect button on the “Overview” page.
Enter a value for idle time out (when the PPP
session will be automatically terminated if no activity
is detected.