Great Dane Surfer GSRKW2352S - Manual (Page 31)

Service Miscellaneous - 29
SERVICE MISCELLANEOUS
c
2. Lift machine with a safe lifting device centered under tire support frame
(A) on the side where tire is being removed.
c
3. Remove wheel nuts (B).
4. Remove wheel.
Installing:
1. Install wheel with valve stem (C) facing out.
2. Install and tighten wheel nuts alternately until recommended torque
value is reached.
• Tighten nuts to 102 N•m (75 lb-ft).
3. Lower machine.
Removing and Installing Front Caster Wheels
Removing:
1. Park machine safely. (Refer to Parking Safely in the SAFETY section.)
2. Lift front of machine with a safe lifting device.
c
3. Remove nut (A) and wheel cap screw (B).
4. Remove wheel and spacers from yoke assembly (C).
Installing:
1. Install replacement wheel and original spacers.
2. Install wheel cap screw (B) and nut (A).
3. Tighten nut until wheel develops slight rolling resistance.
4. Lower machine.
Tightening Rear Drive Wheel Hardware
1. Tighten rear wheel nuts to 102 N•m (75 lb-ft).
c
MX10287
2. Tighten wheel nuts in numbered sequence shown for safe wheel
installation. Tighten alternately until recommended torque value is
reached.
Checking Tire Pressure
c